Wind Turbine Modeling Articles & Analysis
-
Design of simulator for modelling of wind turbine and transfer of maximum power using buck-boost converter
A small wind turbine simulator based on a separately excited DC motor-permanent magnet synchronous generator (PMSG) set has been proposed to evaluate the performance of the small wind turbine model. A DC shunt motor is used to produce varying aerodynamic power by varying field current with the help of an IGBT switch. The simulator is an equivalent gearless wind turbine model that fluctuate ...
-
Dynamic validated model of a DFIG wind turbine
This paper presents the development and qualitative validation of a doubly-fed induction generator (DFIG) wind turbine model that is represented in terms of behaviour equations of each of the subsystems, mainly the turbine rotor, the drive train, the induction generator, the power converters and associated control systems and a protection system. Simulation results obtained from the models are ...
-
Power curve measured and verified – Case Study
In 2010 RSE SpA (Energy System Research Inc.) within a Program Agreement with the Italian Ministry of Economic Development started a measurement campaign on a Libellula wind plant installed in Tuscany. The campaign lasted 1 ½ years and during this time RSE measured the turbine’s power curve following the requirements of the relevant IEC Standard ( EN 61400-12-1 – EN 61400-2). ...
By Aria srl
-
Wind energy and system security – the grid connection moratorium in Ireland
This examines the interaction between technical challenges and policy choices that are made regarding wind power, and uses the grid connection moratorium in Ireland as a case study. While total installed wind capacity in Ireland is low compared with Germany, Spain and Denmark, wind power penetration is higher in the Irish system than in either the British, UCTE or NORDEL systems. In December 2003 ...
-
Terminal characteristics of type 1 wind generating systems with magnetic saturation
This paper proposes a simple method of incorporating magnetic saturation in determining terminal characteristics of a type 1 wind generating system employing a squirrel–cage induction generator. In determining the terminal characteristics, the generator is represented by its traditional per–phase equivalent circuit as well as two–axis model. In both cases, the magnetic saturation is carefully ...
-
A comparative study on the grid integrated wind energy conversion systems (WECS) using different generator models
A huge number of wind generators are going to be connected with the existing network in the near future. Therefore, it is necessary to analyse various models of wind energy conversion systems (WECS) for the purpose of studying the impacts upon grid. This paper presents comparative study on grid connected WECS having two different wind turbine generator systems (WTGS): model 1 [WTGS having doubly ...
-
Turbine suppliers invest in multi-brand services as competition mounts
Wind turbine suppliers are investing in supply chain solutions and combining new technologies with data advantages to win service contracts for third-party turbines, leading suppliers told the Wind Operations Dallas 2019 conference. As intense price competition squeezes margins, turbine suppliers are targeting a greater share of the growing operations and maintenance (O&M) market. ...
-
A combined electro-mechanical control technique for dynamic voltage regulation of a stand-alone wind turbine generator
This paper introduces a computer-based model and dynamic simulation of a combined electro-mechanical control technique for a stand-alone wind turbine generator system. The presented combined control technique consists of three closed loops for speed regulation, nacelle alignment and dynamic load voltage regulation. Speed regulation is achieved by adjusting the pitch angle of the turbine blades. ...
-
Vector control of current regulated inverter connected to grid for wind energy applications
Connecting variable speed wind turbine connected to the grid requires a proper control of the inverter to improve the power quality for the system. The vector control of an inverter connected to the grid is presented. The proposed control technique implies a hysteresis current controller in the inner loop. The complete control system has been developed, analysed, and validated by simulation ...
-
Variable susceptance excitation control for dynamic performance improvement of a stand-alone wind turbine induction generator system
Isolated wind farms employ simple squirrel cage induction generators driven by variable speed wind turbines. Lacking control capability, such generation can contribute very little to network support. Wind turbines mostly do not take part in voltage and frequency control and if a disturbance occurs, the turbines may be disconnected and reconnected when normal operation has been resumed. From ...
-
SIMULWIND - Case Study
Objective: SIMULWIND came into being as a result of the training needs of new professionals in the wind energy sector to face the challenges posed by the digitalisation of wind farms in industry 4.0. The scope of the project consists of the development of a computer simulator designed for training in maintenance and risk prevention in wind farms, with the aim of reproducing the various ...
-
Want low-cost clean energy? Bank on innovation
In the United States, there is a heated debate about how much government should support renewable energy innovation. While you won’t find anyone who says they don’t value ‘innovation’, the U.S. federal investment in energy innovation across both fossil and renewable technology is still anemic, badly trailing China and only about one third of the amount recommended by the ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you