Bioenergy Equipment Supplied In Australasia

The Biogas compressor series C is an oilfree screw compressor in 3 sizes for volume flows up to 1900 m³/h and 3,5 bar overpressure. It is suitable for boosting the intake pressure of treatment plants for biogas (BGTP) or as an essential part of biogas injection plants ...

The biogas compressor series VMY is an oil-injected screw compressor in 3 sizes for volume flows. It is suitable for boosting the intake pressure of treatment plants for biogas (BGTP) or as an essential part of biogas injection plants (BGIP) for the compression of biomethane to inject into gas grids. ...

The gas dome or gas cover is used first and foremost as the basis for various attachments for digesters, i.e., foam traps, gas extraction units, safety devices, mixers, measurement units etc., and secondly as an access point into the digester. For both applications the gas dome should be adequately dimensioned in order to meet all requirements. ennox gas domes comprise of a base unit with a ...

The gravel filter enables the coarse filtration of the biogas by passing through a gravel layer. Foreign particles, foam and condensate are removed and channelled to a drainage point. The filter can be easily accessed through a screwed cover for cleaning. Contamination can be easily removed without the need for opening the cover by rinsing with water. The gravel filter is available for various ...

Digesters and biogas reactors are normally designed and built to cover relatively low system pressures due to cost implications. In order to carry out effective cleaning of the system, operation of a consumer or transfer of the biogas, it is necessary to increase the operating pressure in the pipework. ...

The SgPur system is specifically designed to treat sour gas from oil and gas operations. The system reduces hydrogen sulfide (H2S) concentrations and converts it to solid elemental sulfur for resale. The system uses a liquid chemical catalyst, compact gas/liquid contactor, and solids removal system and does not consume the chemical catalyst driving the conversion of H2S to sulfur, minimizing ...

ACME Steam Superheaters are available for operating pressures of up to 800 PSIG and temperatures up to 1200 deg. F. Steam flow is only limited by practical size considerations. Pressure sections are built to ASME code with National Board or CRN registration. Burners are AGA or CGA listed with UL, CSA or other gas train standards as requested or applicable. The ACME Steam Superheater is delivered ...

Contacting INCINER8 is the first step in the process of solving any waste problem. No matter what our clients waste stream is be it large or small amounts of waste, our Research and development team, with over 30 years of combustion and product engineering experience, will have a solution to any challenge. We work together with our clients through the designing, manufacturing and technology ...

The sediment trap removes sediment particles or condensate water which may accumulate in the gas system. The contaminated and/or saturated gas is set into a spiral motion within the container by a special inlet nozzle. The heavier particles and water collect on the side walls of the unit, where they then accumulate at the bottom of the container. Drainage can be achieved either manually or ...

AERZEN process gas compressors are installed as single or multiple stage units in chemical, petrochemical, raw material and energy producing plants and in many other production centres of the processing industry all over the world. The unit is ideally suited for dry compression of all gases in chemical and petrochemical industries. Technical Data: Suction volume flow up to: 75.000 m³/h, ...

In general the design for those flares is the same as for our standard flares. In accordance with the project-specific requirements (for example special gas composition, high gas temperatures or pollution) specific technical solutions and equipment are added. In principle all pyrolysis gas flares are individually customized, designed and calculated. All syngas flares have an own supporting burner ...

The double membrane gasholder is made up of two spherical shaped polymer membranes (other forms are also possible), lying one inside the other. The external membrane is maintained in a stable form with the use of an air blower. The external membrane then serves as protector for the inner membrane against the influence of environmental factors such as wind or snow. The biogas is contained within ...

W,W,W separators, O.D. × L 8 mm × 150 mm, pkg of 50 ...

W,W,W separators, O.D. × L 6 mm × 70 mm, pkg of 25 ...

ORBO Carboxen-564 Tube for analyte group MEK (methylethyl ...

W,F,F separators, O.D. × L 6 mm × 75 mm, pkg of 50 ...

ORBO 354, 100/50 mg, 50 ...

TBC on Charcoal Tube Bed A 400 mg, Bed B 200 ...

The demand for SPE cartridges with improved flow characteristics and reduced susceptibility to the formation of fines has led to the development of a family of SPE tubes packed entirely with spherical, non-friable particles. The Supel Sphere Carbon/NH2 dual layer SPE tube contains both spherical carbon particles and spherical aminopropyl (NH2) modified silica . It was developed to offer superior ...

ORBO-78 400/200 MG ...