7 products found

Bilgeri EnvironTec GmbH Products

• Equipment for Anaerobic Digesters

• 

  Model FT - Biogas Foam Trap

  Under certain circumstances during the operation of anaerobic digesters, foam formation can occur on the upper layers, caused by an imbalance of mixing processes in the reactor, gas injection, specific characteristics of the sludge, temperature , etc. The EnvironTec's foam trap can instantly detect the formation of foam using capacitive or photoelectric sensors and impede foam penetration in the gas extracting system by washing it down. • Detection and ...

• Biogas Treatment / Biogas Conditioning

• 

  Model BDS - Biological Desulphurization System

  Biogas always contains hydrogen sulphide (H2S). Usually, it moves in the range of 1,000 to 6.000ppm, but it can also reach 2% by volume or more. Often this H2S must be removed from the gas, either because of environmental protection reasons or because corrosion danger. The EnvironTec's desulphurization process provides a cost- effective yet highly efficient solution for it. It is a biological process that requires no chemicals and little consumable ...

• Biogas Flares

• 

  Model FA II - Closed-combustion Automatic Biogas Flare

  The FAII biogas flare is an automatic, enclosed gas flare for combustion of biogas and other combustible gases, fully complying with the widely applied German air pollution regulation TA Luft. +500 references in more than 50 countries witness the robustness of our FAII flares! Available in a rage of 20 - 3.000 Nm3/h, at various pressures. Highly customizable for very particular project ...

• 

  Model FA I - Manual / Automatic Open-Combustion Biogas Flare

  The FAI is an open-combustion flare, which can be configured in manual ignition as standard. Optionally, the FAI can be updated to Automatic mode, before or after* purchasing. That makes the New FAI the best and most cost-effective option for locations where no automatic flare is mandatory and open combustion is allowed! Available up to 500 Nm3/h, from 2,5 to 20 ...

• 

  Model HT - High Temperature Gas Flare

  The HT series flares are designed to offer a combustion temperature above 1000 °C and residency time longer than 0,3 s. This is to comply with the widely-applied German norm TA-Luft, in those case in which the flare is not just an emergency element, as well as in case of landfills and other complex and special gases. The HT features heat-resistant ceramic insulation, automatic air intake regulation and temperature control, as well as automatic ignition ...

• Biogas Storage

• 

  Model TGZ - Non-Pressurized Gas Storage System

  EnvironTec's TGZ non-pressurized gas holder consists of a prefabricated metal silo made of corrugated steel segments with lateral stiffeners attached to it and a conical roof. Inside it, a tight, high quality, UV-and-fungus-resistant membrane treated with flame retardant (DIN 4102 B1), is connected to the top and the bottom of the silo structure using AISI316Ti flanges, avoiding the membrane to be in contact with the silo walls. Additionally, a protective ...

• 

  Model DMG - Double Membrane Biogas Holder

  Very usual technology in biogas applications, the double membrane gas holder consist of two three membranes forming a sphere cap with the ground. The outer membrane forms the actual protective construction and is always exposed to a positive pressure required for structural integrity. The processes inside the storage container can always be monitored through an inspection glass built into the outer membrane. The actual useable storage space is formed by ...