Flame Monitoring Equipment Supplied In USA

Whether you are building a new facility or updating an existing one, there are a myriad of safety decisions to make. One decision, however, is now crystal clear. To best protect your workplace and employees, choose the 7800 Controller. Five simple function buttons make configuration and setup of the 7800 Controller easy and intuitive. Built-in programming flexibility allows you the ability to ...

Designed for vapors from PRODUCED OIL OR WATER TANKS as well as PRODUCED GAS, MRW Non-Assist Smokeless Flares don't require forced air for smokeless combustion at infinite turndown. Vapors from multiple low-pressure tanks and high pressure sources can be controlled with a single open flame system. Built to meet 40 CFR 60.18 and operate with no visible emissions, MRW Smokeless Tank Battery Flares ...

Syngas, also known as synthesis gas, synthetic gas or producer gas, can be produced from a variety of different materials that contain carbon. These can include biomass (wood gas), plastics, coal, municipal waste or similar materials. Historically town gas was used to provide a gas supply to many residences in Europe and other industrialised countries in the 20th Century. Gas engines utilising ...

The new HFC All-In-One Compact Flame Scanner was meticulously designed for continuous, intermittent, and 72-hour operation. The flame scanner's durable housing integrates both the scanner and amplifier into one subcompact assembly, which reduces overall cost and simplifies installation tremendously. Additional costs normally required for mounting the control electronics in a separate, service ...

NAO flame arrestor burners used for NCG (non-condensable gases) in the pulp & paper industry. This unit shown is a forced draft FOUR stream waste burner -- including liquid turpentine and NCG ...

Our flame arrestors prevent flame propagation by absorbing and dissipating heat using spiral wound crimped ribbon flame cells. These cells allow maximum flow with maximum ...

The Flame-Monitor Flame Safeguard Series provides the proper burner sequencing, ignition and flame monitoring protection on automatically ignited oil, gas and combination fuel burners. On a safety shutdown, the display module will advise the operator that the control is in "Lockout" and indicate the cause as well as the position in the operating sequence that it ...

The BurnerPRO™ provides the proper burner sequencing, ignition and continuous flame monitoring for commercial heating and process equipment firing oil and gas fuels. BurnerPRO Flame Safeguard (BP110UVF/BP230UVF) Control, with integrated flame safeguard and boiler control operation, provides simplified operation for single point applications. The system is designed for use in non-permanent ...

The BurnerPRO™ provides the proper burner sequencing, ignition and continuous flame monitoring for commercial heating and process equipment firing oil and gas fuels. BurnerPRO BP110UV-S1, S2, S3 and BP230UV-S1, S2, S3 controls are functionally compatible with select Siemens LFL control models. Use existing wiring base with no external wiring changes. The controls are also compatible with ...

Test Flares are used during system setup, and for periodical system tests and maintenance. They represent large loads, and allow the system to be tested under simulated load conditions. AES manufactures standard test flares with 2" or 3" gas lines. Other flares for specific systems are available as customer specials. All AES test flares are equipped with automatic ignition, standing pilot, ...

The HERO Low Flow Flare is specifically designed for low flow flare applications, or for those sites located in remote locations and do not have access to electric or pilot fuel gas. The most common application is flaring off low pressure tank vapors and remote ...

The Tornado Pilot Monitoring and Auto-Relight (TPMR) System is the most reliable ignition system for flare stacks. The TPMR System consists of a continuous pilot and a self-contained relight system, with very low fuel consumption (25 SCFH). The assembly is fully retractable to grade for easy inspection and servicing without the need for ladders, platforms, pickers or ...

Heat anywhere with this portable waste oil heater. Mobile and self contained for use on job sites and other outdoor or very well ventilated applications. Use a variety of fuels to produce up o 150,000 BTU's per hour. Enjoy years of FREE RADIANT HEAT, low maintenance and clean waste oil burning. See more info at geaux ...

NAO hydrogen flame arrestor burner used for chemical and process applications. The arrestor is shown with an water jacket for cooling of the arrestor grid to prevent ...

Specials are no problem for NAO, we can meet your needs & requirements -- proof testing for full scale mockup with your full piping ...

The Model 100 Continuum Ignitor utilizes a high voltage electric arc to ignite a combustible air/gas mixture. This arc typically occurs every 20 seconds for a two second duration (timing is adjustable). The Continuum provides a spark inside a ‘slipstream’ chamber that diverts a portion of the waste gas to create a combustible air/gas mixture. This allows the Continuum ignitor to ...

Our Titan Demountable Flares, also named demountable derricks, are derrick-supported flares with three, or four leg configurations and overall heights of up to 200 meters. Designed to accommodate several risers/tips on the same derrick structure. Each flare tip has its own set of pilots. The demountable system allows maintenance at grade on each flare tip while keeping the other flare systems in ...

The Sentinel flame monitor reliably provides remote flame detection up to 550 feet away, durability, ease of maintenance and rapid response time. If the monitor detects the absence of a flame for an adjustable amount of time, a set of dry form C contacts are activated and the pilot re-ignition system is set into motion. Response times are markedly quicker than those of a standard thermocouple ...

To dispose of heavy waste gases, which have a greater tendency to smoke, in a smokeless manner, we provide three different design options, depending on customer requirements. Air Assisted Flares, which utilize forced air from blower(s) to provide assist air for combustion and promotes additional air entrain from the ambient due to the relatively high exit speed of the streams. Steam Assisted ...

The Ghost series of enclosed biogas flares is a simple and cost effective combustion solution for a variety of applications where a hidden flame is required. The superior design, high quality stainless steel construction and unmatched versatility make the Ghost Series Enclosed Flares an exceptional choice for emissions control within the biogas and wastewater industries. Additionally, each ...